Brass Pipe Weight Calculator

Brass Pipe Weight Formula:

\[ Weight = \pi \frac{(OD^2 - ID^2)}{4} \times L \times Density \]

Outer Diameter (OD):

Inner Diameter (ID):

Length (L):

Density:

kg/m³

Weight:

Unit Converter ▲

Unit Converter ▼

From:	To:

1. What is the Brass Pipe Weight Formula?

The brass pipe weight formula calculates the weight of a brass pipe based on its dimensions and material density. It provides an accurate estimation of weight for engineering, manufacturing, and shipping purposes.

2. How Does the Calculator Work?

The calculator uses the brass pipe weight formula:

\[ Weight = \pi \frac{(OD^2 - ID^2)}{4} \times L \times Density \]

Where:

\( OD \) — Outer diameter of the pipe (meters)
\( ID \) — Inner diameter of the pipe (meters)
\( L \) — Length of the pipe (meters)
\( Density \) — Density of brass material (kg/m³)

Explanation: The formula calculates the cross-sectional area of the pipe wall and multiplies it by length and density to determine total weight.

3. Importance of Weight Calculation

Details: Accurate weight calculation is crucial for structural engineering, material costing, transportation planning, and inventory management in manufacturing and construction industries.

4. Using the Calculator

Tips: Enter all dimensions in meters. Standard brass density is approximately 8500 kg/m³. Ensure outer diameter is larger than inner diameter for valid calculations.

5. Frequently Asked Questions (FAQ)

Q1: What is the typical density of brass?
A: Brass density typically ranges from 8400-8700 kg/m³, with 8500 kg/m³ being a common average value used in calculations.

Q2: Can I use different units for measurements?
A: The calculator requires meters for all dimensions. Convert from other units (mm, cm, inches) before entering values.

Q3: How accurate is this calculation?
A: The calculation provides theoretical weight based on perfect geometry. Actual weight may vary slightly due to manufacturing tolerances and material composition.

Q4: Does this work for hollow rectangular brass tubes?
A: No, this formula is specifically for circular pipes. Different formulas are needed for rectangular or other cross-sectional shapes.

Q5: What if my pipe has different brass alloy?
A: Different brass alloys have slightly different densities. Use the specific density value for your particular brass alloy for most accurate results.